FNXBasic

When i open in the editor a file with a unc path (\) then i get an error, i see the path doubled in the error message.
After that i can`t open a .bas file, the statusbar is changed but the richedit keeps the old text.

Hi fred i do not understand it fully, within the filedialog it is not possible to fil in an unc path because its only possible to fill in a filename.
Where do you enter the unc path?

best regards

I open "Mijn Documenten" (connected to a network share/drive letter) and enter a subfolder.
Then opening a file i get the error: Cannot create file "\fs1userdirUSERTestfs1userdirUSERTest est_read.bas" because this path does not exists.
The path looks replicated.
After this error i can`t open other files anymore.
If i use the drive letter (which connects to the same folder) the file is loaded by the editor.

Thanks, i`ve solved the problem the next update can open and run unc files.
best regards